today my RC plane arrived
so i assembled it and was testing it out
and it was perfectly fine and everything seemed to be in good shape
than out of curiousity i pulled out this tiny chip-looking thingy from the remote controller; it said FM on the side
it was probably as big as my thumbnail and had 2 electric wires at the end
and since then, i cannot control my RC through my remote
if i give the plane power, it just spontaniously does its own stuff
regardless of what my remote tells it to do
so,.,how do i fix this?
thx
that’s the crystal put it back if you did and it still dose not work you may have cracked it or pulled out one of the wires in Tx if so send it back and act dumb about it with out it your done.
Should I use a gas engine or a electric for a RC airplane?
Related posts:
- HPI Racing EDF RC Plane Nitro
- How do you start up an electric Rc plane?
- Boeing Radio Controlled Plane Nitro
- Piper Radio Controlled Plane Nitro
- Heli-Max RC Trainer Helicopter Electric
If you're new here, you may want to subscribe to my RSS feed. Thanks for visiting!
{ 1 comment… read it below or add one }
that’s the crystal put it back if you did and it still dose not work you may have cracked it or pulled out one of the wires in Tx if so send it back and act dumb about it with out it your done.
References :
28 years in RC